Replacing the REAR tyre and inner tube of Wayscral Kickway E1

Intro : Wayscral Kickway E1 Rear Tyre

Let’s see together how to replace the punctured inner tube of a Wayscral KickWay E1 electric scooter on the rear wheel.

Required Tools :

A 17mm wrench
A 4mm Allen wrench
A 3mm Allen wrench
A new inner tube 8 1/2 x 2L
If your tire is too worn : an original tire size 50/75-6.1 or a CST V3 tire with the size 8 1/2 x 2

🛒 Front and Rear Inner Tubes for Wayscral Kickway E1 (8.5×2, angled valve 70/90)

What inner tubes for Wayscral Kickway E1 electric scooter ?

For the inner tube, it needs to have a size of 8 1/2 x 2L with a bent valve of 70/90. This simply means that the valve is bent at a 70-degree angle and oriented 90 degrees outward from the inner tube.

⚠️ It is important to choose the 8 1/2 x 2L inner tube (and not just 8 1/2 x 2).

The 8 1/2 x 2 inner tube is compatible only for the front wheel,
while the 8 1/2 x 2L inner tube is compatible for both the front and rear wheels.

The best option for your Wayscral Kickway E1 scooter is to choose an 8 1/2 x 2L inner tube with a bent valve of 70/90 and an inner diameter of 15cm.

Removing the covers

Alright, let’s get started. Using a 3mm Allen wrench, unscrew the two screws that hold the plastic cover in place.

We remove the second cover from the other side of the scooter.

Disconnecting the motor

We disconnect the motor by pulling on the two ends of the connector.

Removing the rear wheel

We unscrew the two nuts on the left and right of the rear wheel using a 17mm wrench.

Once the two nuts are sufficiently loosened, we can pull the rear wheel downward and set it aside.

Removing the rear brake disc

We remove the brake disc by unscrewing the 6 small screws using a 3mm Allen wrench.

Removing the old tire and punctured inner tube

We will check to ensure that there is no air left in the tire.

Next, we will unscrew the 6 screws of the rim using a 4mm Allen wrench.

Once the screws are removed, we can lift the half-rim and remove the old tire and punctured inner tube.

Installing the new inner tube

We take our new tire and new inner tube.

We check the direction of rotation indicated on the side of the tire.

And we place the inner tube inside the tire.

We insert the valve of the inner tube into its housing.

We place the half-rim back in its position and gradually tighten the 6 screws to secure everything back together.

Rear tyre pressure for Wayscral Kickway E1

You can inflate your tire between 2.5 and 3.5 bars depending on your weight and the desired riding sensations.

Reinstalling the brake disc in the correct orientation

We proceed to screw the brake disc back onto the rear wheel. Normally, the direction of rotation is indicated on the disc, but if it’s not, you can look at the disc’s tabs, which should point downwards when you ride.